Getting Started: Cocktail Smokers

Tips and Tricks

• The colder the glass when smoked the longer and better the smoke adheres to the sides.  This will cause the flavor to go in the drink more and with each sip you will breath in some fantastic smoky goodness!
• The higher the liquid is in the glass, the less overall smoky taste you will get because the smoke cannot penetrate below the liquid line. 
• When using the torch. It is best to rotate the top so it is no longer straight. If it is straight then it could sputter a bit and you'll need to keep pressing the ignition.
• It is normal for some smoke leakage between the cocktail smoker that the top of the glass.  This comes from rim of the glass not being perfectly level.
• Everyone is different on how much of a smoky flavor they want in their drink.  A lot comes with trial and error and the type of chips.  For example, apple and cherry will have a milder smelling smoke and will need to stay in the glass longer.  Texas Mesquite, however, is a more intense and you would not want to have it on as long as you would the apple and cherry.  But it still comes down to personal preference.
• The black stainless steel smoke chambers will be extremely hot so it is a good idea to not grab that after use.  Simply handle the cocktail smoker by the wooden sides.

1. Fill your chambers with the desired chips.  You can use different chips in each chamber (for two hole smokers).
2. Once the first glass is smoked, immediately take off the cocktail smoker and replace with the top.  Do this quickly so you don't lose that much smoke from the glass.
3. Place the cocktail smoker onto the second glass and smoke it with the other chamber.  Leave the smoker on the second glass.
4. Depending on the chips used and personal preference, a good guide is leave them covered for about a minute. Texas Mesquite is strong, so be careful.
5. Once you reach your desired smoke flavor in your drinks, remove the top piece and the smoker piece.
6. Enjoy! 

About the Butane Fuel

If you have ordered a kit with a torch, then you will not need to purchase butane fuel separately as it will be included with your kit!  You can enjoy smoking cocktails immediately.

How to Use Your Butane Torch

Gas Filling

1. Use only high quality butane fuel.
2. Never fill in the presence of an open flame or sparks.
3. Never fill a lit or hot torch.
4. Before filling gas, use a ball point pen or small screwdriver to drain any remaining butane fuel from the lighter by depressing the filling valve.  The torches we send are all empty of butane fuel.
5. Shake gas cylinder a couple of times.
6. Hold torch upside down and insert nozzle into the gas filling valve. See image below.
7. Push the tip of the fuel can into the filling valve. It will take around 10 seconds for the tank to be completely full.
8. Once full, it will spit a little bit but will evaporate right away. Let the torch rest for a few minutes before lighting.

Operating Instructions

1. To ignite the torch, first press and hold the ignition button.  Once you release the flame will extinguish.
2. To use the safety lock, press and hold the ignition button.  While flame is burning, push down on the safety lock the release the ignition button, the flame will keep burning.
3. Adjust the flame as needed with the Gas Flow Regulator.
4. The torch head is adjustable (rotatable) for multiple use.
5. The torch works best with it NOT in the straight position.

For safety, keep the lock on the down position when not in use.